-
When you charge the shaver for
the first time or after a long
period of non-use, let it charge
continuously for 12 hours.
Charging normally takes 10
hours.
Caution: Do not leave the
appliance connected to the wall
socket for more than 24 hours.
Note: You cannot use the appliance
while it is charging.
1
Make sure the appliance is
switched off.
2 Put the supply unit in the wall
socket and put the small plug in
the appliance (Fig. 4).
3 After charging, remove the
supply unit from the wall socket
and pull the small plug out of
the appliance.
Using the appliance
Note: This appliance can only be
used without cord (Fig. 5).
Switching the appliance on
and off
-
To switch on the appliance,
push the on/off slide upwards
(Fig. 6).
-
To switch off the appliance,
push the on/off slide
downwards (Fig. 6).
Skin adaptation period
Your first shaves may not bring you
the result you expect and your skin
may even become slightly irritated.
This is normal. Your skin and beard
need time to adapt to any new
shaving system. To allow your skin
to adapt to this new appliance, we
advise you to shave regularly (at
least 3 times a week) and
exclusively with this appliance for a
period of 3 weeks.
1
Switch on the appliance.
2 Move the shaving heads over
your skin. Make both straight
and circular movements (Fig. 7).
Note: Shave on a dry face only.
Do not use the shaver in
combination with shaving gel,
shaving foam or water.
3 Clean the appliance after use.
Cleaning and
maintenance
Cleaning the shaver under
the tap
Clean the shaver after every use for
optimal performance.
Be careful with hot water. Always
check if the water is not too hot, to
prevent burning your hands.
Caution: Never dry the shaving unit
with a towel or tissue, as this may
damage the shaving heads.
1
Switch off the appliance and
disconnect it from the wall
socket.
2 Rinse the shaving unit under a
warm tap (Fig. 8).
-
For additional cleaning you can
also start by using the cleaning
brush to remove hairs (Fig. 9).
3 Pull the shaving unit off the
shaver in a straight upward
movement (Fig. 10).
4 Rinse the shaving unit (Fig. 13)
and hair chamber (Fig. 11) under
a warm tap.
-
For additional cleaning you can
also start by using the cleaning
brush to remove hairs.
5 Carefully shake off excess water
and let the shaving unit and hair
chamber dry (Fig. 13).
6 Put the shaving unit back onto
the shaver (Fig. 14).
Every two months: shaving
heads
Note: Do not use cleaning agents or
alcohol to clean the shaving heads.
Only use Philips Cleaning Spray
(HQ110).
1
Switch off the shaver, remove
the supply unit from the wall
socket and pull the small plug
out of the shaver.
2 Pull the shaving unit off the
shaver in a straight upward
movement (Fig. 10).
3 Turn the orange wheel
anticlockwise and remove the
retaining frame (Fig. 15).
4 Remove and clean one shaving
head at a time. Each shaving
head consists of a cutter and a
guard (Fig. 16).
Note: Do not clean more than
one cutter and guard at a time,
since they are all matching sets.
If you accidentally put a cutter in
the wrong shaving guard, it may
take several weeks before
