Mounting
9
PLPROFILE1 MKII LED Luminaires
Installation & User’s Manual
4. Mounting
WARNING!
Before attempting any installation or service, disconnect all power at power source. Dimming the
luminaire does not disconnect power. Installation and service should only be performed by a trained and qualified
professional.
Using Supplied C-Clamp
As illustrated in
, at yoke assembly, thread clamp mounting bolt (with washer installed) through center clamp
mounting hole at top of yoke, through Top Box Assembly, and thread bolt into C-Clamp. Securely tighten bolt (by
hand) into clamp (but do not over-tighten).
Note:
Top box will be able to swivel once bolt is tightened by design. DO NOT OVER-TIGHTEN!
Figure 5: Luminaire Mounting
To mount on a telescopic stand, reverse the yoke under the luminaire and bolt to stand. Please note luminaire
orientation (see note in
) for proper cooling.
Note:
After installing Clamp and Top Box assembly, connect luminaire cable assembly to Top Box Assembly before
mounting luminaire. Please note that the cable connector is keyed.
Yoke Assembly
Center Clamp Mounting Hole (13 mm)
NOTE:
To allow for proper cooling, make sure
luminaire head is orientated as shown (with
cooling vents pointed upwards).
Top Box Assembly
C-Clamp
Flat Washer
C-Clamp Bolt*
Top Box Assembly
Luminaire Cable Assembly
WARNING!
*When installing a C-Clamp (or hook,
or other type of clamp) with the Top Box Assembly
as shown, you MUST use the C-Clamp Bolt
supplied with the fixture. Failure to do so may result
in damage to the Top Box Assembly or cause the
luminaire to dislodge from the clamping device.
Flat Washer
Содержание PLZS1MKII-1834-03
Страница 1: ...For PLZS1MKII 1834 03 PLZS1MKII 2444 03 ...
Страница 40: ......
