EN 30
Fine-tune analogue channels
If the reception of an analogue TV channel is
poor, you can fine-tune the TV channel.
1. Press .
2. Select
[Setup]
>
[Channel settings]
>
[Channel installation]
.
3. Select
[Analogue: Manual antenna
installation]
>
[Fine tune]
, and then press
OK
.
4. Press or to fine-tune the channel.
5. When you have selected the correct
channel frequency, select
[Done]
, and then
press
OK
.
6. Select an option, then press
OK
.
[Store current channel]
: Store the
channel as the current channel number.
[Store as new channel]
: Store the
channel as a new channel number.
Update channel list
When the TV was switched on for the first
time, a full installation of channels was
performed.
By default, when there are changes to these
channel lists, the TV updates them
automatically. You can also switch off the
automatic update or manually update the
channels.
Note
: If you are prompted to enter a code,
enter '8888'.
Automatic update
To add or remove digital channels
automatically, leave the TV in standby mode.
The TV updates channels and stores new
channels everyday. Empty channels are
removed from the channel list.
Switch off the channel update message
If a channel update is performed, a message
is displayed at startup. You can switch off this
message.
1. Press .
2. Select
[Setup]
>
[Channel settings]
or
[Satellite settings]
.
3. Select
[Channel installation]
>
[Channel
update message]
.
4. Select
[Off]
, then press
OK
.
To switch off automatic updates
In the
[Channel installation]
menu, select
[Automatic channel update]
>
[Off]
.
Update channels manually
1. Press .
2. Select
[Setup]
>
[Search for channels]
>
[Update channels]
, then press
OK
.
3. Follow the onscreen instructions to
update the channels.
Satellite settings
What you can do
View satellite channels
Note:
Satellite signal is available on certain
models only.
[Search for satellite]
is only available if
the TV supports DVB-S.
To receive satellite channels, connect a
satellite receiver to the SAT connector
on your TV.
LNBs
This TV can receive signals from 4 different
low noise block-down converters (LNBs).
An LNB is mounted at the end pole of the
dish antenna and captures signals from a
satellite.
