Philips MX-1050D, Руководство по обслуживанию

Страница: 13 / 59

DISMANTLING INSTRUCTIONS
3-1 3-1
Dismantling of the DVD Module and/or Digital Board
1) Loosen 10 screws A to remove the DVD Digital Board
cover as shown in figure 2.
Note: Use step 3 to remove the Digital Board without
dismantling the complete DVD Module.
2) Loosen 6 screws B (including 2 metal mounting brackets)
and 2 catches C1 as shown in figure 4 and 5. Disconnect
4 cables (see figure 6) and remove the DVD Module by
lifting its rear end upward and sliding it out of the Front
Metal plate.
Note: - Care should be taken not to entangle / damage
the grounding springs along the DVD enclosure
wall.
- Do not loose the 2 metal mounting brackets.
3) Loosen 4 screws D (see figure 6) and all connectors to
remove the Digital Board.
1) Open the DVD Tray by using the Open/Close Button while
the Set is ON and disconnect the mains supply after
removing the Tray Cover.
Note: If this is not possible, the DVD Tray has to be open
manually.
To manually open the DVD Tray, place the set on its right
side. Insert a mini flat screw driver into the slot and slide
it upwards as shown in figure 2 until the Tray moves out of
the Front Panel.
Dismantling of the Front Panel Assembly
2) Return the set to its upright position and remove the Tray
Cover as shown in Figure 1 and close the tray manually by
pushing it back in.
3) Loosen 9 screws and remove the Top Cover by lifting the
rear portion upwards before sliding it out towards the rear.
- 5 screws on the rear
- 2 screws each on the left & right side
4) Loosen 5 screws & lift up the top edge of Front Panel
assembly to free some catches (see figure 3) before
sliding it out towards the front.
- 3 screws on the bottom
- 1 screw each on the left & right side
Figure 1
Figure 3
Figure 4
Figure 6
Figure 2
Figure 5