Philips MCM277/05, Руководство пользователя

Страница: 12 / 28

12
English
Preparation
Setting the clock
After connecting MCM277 to the power supply,
set the clock first.
1
Press and hold
STANDBY-ON/ ECO
POWER to switch the set to Standby mode
➜
The display shows the set time
➜
-- --:-- -- flashes by default if you have not set
the clock
2
In the standby mode, press and hold DISPLAY/
CLOCK
on the remote control
➜ SET CLOCK
scrolls on the display
➜ 24 HR
or
12 HR
appears for the initial
clock setting. To select 24-hour clock or
12-hour clock,
●
On the remote control, press VOL +/-
once or more (or turn VOLUME on the
set)
●
On the remote control, press DISPLAY/
CLOCK to confirm
➜
The hours digits start flashing
3
Hold down or press VOL +/- repeatedly to set
the hours (or turn VOLUME on the
set)
4
Press DISPLAY/CLOCK to confirm
➜
The minutes digits start flashing
5
Hold down or press VOL +/- repeatedly to set
the minutes (or turn VOLUME on the
set)
6
Press DISPLAY/CLOCK to confirm
– To exit without storing the clock setting press
STOP
9
Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The set will exit from the clock setting mode if
no button is pressed within 90 seconds.
– To set the clock automatically by using a time
signal which is broadcast together with the RDS
signal see chapter
RDS: Automatic clock
setting via RDS .
Using the remote control
IMPORTANT!
– Remove the protective plastic tab before
using the remote control.
– Always point the remote control directly
towards IR area.
Remove the plastic protective sheet
Notes for remote control:
– First select the source you wish to
control by pressing one of the source select
keys on the remote control (for example
CD, TUNER).
– Then select the desired function (for
example
ÉÅ
,
4
,
¢
).
To replace the remote controls’
battery
1
Press and hold
1
as indicated.
2
Simultaneously, pull the battery tray at
4
.
3
Remove the old battery and put a new CR2025
battery in place.
4
Put back the battery tray.
1
2
3
CR2025
CAUTION!
– Remove the battery if it is exhausted
or will not be used for a long time.
– Batteries contain chemical substances,
so they should be disposed of properly.
– Danger of explosion if battery is
incorrectly replaced. Replace only with
the same or equivalent type.
P001-P028_MCM277_05_Eng 2008.1.17, 16:06 12