5
How to connect a plug
The wires in the mains lead are coloured with
the following code: blue = neutral (N), brown
= live (L).
As these colours may not correspond with the
colour markings identifying the terminals in
your plug, proceed as follows:
Connect the blue wire to the terminal
•
marked N or coloured black.
Connect the brown wire to the terminal
•
marked L or coloured red.
Do not connect either wire to the earth
•
terminal in the plug, marked E (or ) or
coloured green (or green and yellow).
Before replacing the plug cover, make certain
that the cord grip is clamped over the sheath
of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may
require consent. see Copyright Act 1956 and
The performer’s Protection Acts 1958 to
1972.
Caution
Use of controls or adjustments or
•
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Warning
Where the MAINS plug or an appliance
•
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
Warning
Never remove the casing of this unit.
•
Never lubricate any part of this unit.
•
Place this unit on a fl at, hard and stable
•
surface.
Never place this unit on other electrical
•
equipment.
Only use this unit indoors. Keep this unit away
•
from water, moisture and liquid-fi lled objects.
Keep this unit away from direct sunlight, naked
•
fl ames or heat.
Never look into the laser beam inside the unit.
•
Install all batteries correctly, + and -
•
as marked on the unit.
Do not mix batteries (old and new
•
or carbon and alkaline, etc.).
Remove batteries when the unit is
•
not used for a long time.
o
Apparatus shall not be exposed to
dripping or splashing.
p
Do not place any sources of danger on
the apparatus (e.g. liquid fi lled objects,
lighted candles).
q
This product may contain lead and
mercury. Disposal of these materials
may be regulated due to environmental
considerations. For disposal or recycling
information, please contact your local
authorities or the Electronic Industries
Alliance: www.eiae.org.
Safety-Important notes for users in
the U.K.
Mains plug
This apparatus is fi tted with an approved 13
Amp plug. To change a fuse in this type of plug
proceed as follows:
a
Remove fuse cover and fuse.
b
Fix new fuse which should be a BS1362 5
Amp, A.S.T.A. or BSI approved type.
c
Refi t the fuse cover.
If the fi tted plug is not suitable for your
socket outlets, it should be cut off and an
appropriate plug fi tted in its place.
If the mains plug contains a fuse, this
should have a value of 5 Amp. If a plug
without a fuse is used, the fuse at the
distribution board should not be greater
than 5 Amp.
Note: The severed plug must be disposed
off to avoid a possible shock hazard
should it be inserted into a 13 Amp
socket elsewhere.
English
EN
