![background image](http://html.mh-extra.com/html/philips/mc-77/mc-77_service-manual_311579044.webp)
10-2
The following steps have to be done when replacing the CD mechanism:
1. Disconnect flexfoil from old CD drive
2. Put a paperclip over contacts of flexfoil to short-circuit the contacts (fig.1)
3. Remove old CD drive
4. Remove paperclip from flexfoil
5. Connect flexfoil to new CD drive
6. Remove ESD-protection (solder joint) from laserunit (see below)
7. Position new CD drive in its studs
CHARGED CAPACITORS ON THE SERVO BOARD MAY DAMAGE THE CD DRIVE ELECTRONICS WHEN
CONNECTING A NEW CDM MECHANISM. THAT´S WHY, BESIDES THE SAFETY MEASURES LIKE
• SWITCH OFF POWER SUPPLY
• ESD PROTECTION
ADDITIONAL ACTIONS MUST BE TAKEN BY THE REPAIR TECHNICIAN.
WARNING
fig.1
Attention: The laser diode of this CD drive is protected against ESD by a solder joint which shortcircuits the
laserdiode to ground.
For proper functionality of the CD drive this solder joint must be removed after connection the drive to
the set.
Содержание MC-77
Страница 10: ...2 6 Technical Remarks ...
Страница 15: ...4 1 4 1 SET BLOCK DIAGRAM MC 77 dd wk0210 DIGITAL AMP 6Ω 70W ...
Страница 42: ...9 10 Technical Remarks ...
Страница 45: ...10 3 WIRING Module WIRING CD Drive ...