Connecting a camcorder to
CAM 1 or CAM 2
You can connect a camcorder to the connections CAM 1
or CAM 2 on the front of the set. The picture quality
depends on the type of connection between the
camcorder and the DVD recorder system:
– good quality: Composite Video (Video CVBS)
– better quality: S-Video
– best quality: i.LINK (IEEE 1394, FireWire)
Select the best connection available. Only one video
connection between the DVD recorder system and the
camcorder is needed.
1
Open the flap on the front of the DVD recorder system.
2
Connect the camcorder to CAM 1 or CAM 2 following the
instructions in the user manual of your camcorder.
Note: If the camcorder connected to
CAM 1
has mono
sound only, connect the audio output of the camcorder to
CAM 1 / AUDIO R
on the DVD recorder system.
Connecting headphones
1
Open the flap on the front of the DVD recorder system.
2
Connect the headphones with a 3.5 mm plug to PHONES
on the DVD recorder system.
➜
The speakers are switched off automatically. Sound will
be reproduced through the headphones only.
Note: With connected headphones, no surround sound is
available. If you press
SURR.
,
DISCONNECT HEADPHONES
will be scrolled on the display of the DVD recorder system.
Mains
The type plate is located on the bottom of the set.
1
Check whether the mains voltage as shown on the type
plate corresponds to your local mains voltage. If it does not,
consult your dealer or service organisation.
2
Make sure all connections have been made before
connecting the DVD recorder system to the mains
supply.
3
Connect the mains cable to the wall socket.
When the set is switched to standby, it is still consuming
some power.
To disconnect the set from the mains
completely, remove the mains plug from the wall
socket.
For users in the U.K.: please follow the instructions
on page 2.
To avoid overheating of the set a safety circuit has
been built in. The set will turn down the volume or
switch off sound completely if it becomes too hot. If
this happens, wait until the set has cooled down.
When you connect the DVD recorder system to the mains
supply for the first time, you need to perform some basic
settings. See “Initial installation”.
Connecting other equipment / Mains
16
English
S-Video
Video, CVBS,
Composite Video
i.LINK
(IEEE 1394, FireWire,…)