LX25, LX50, LX95 SERIES
Manufactured by:
Vision Solaire inc.
www.vision-solaire.com
T. 1-819-729-0450
Révision: 2.4
IMPORTANT NOTES:
• Always install the lighting fixture on the pole before installing the battery.
• The lighting fixture should never be handled with battery installed inside.
• The battery compartment contains a “quick connector” to connect the battery, identified as
“BATTERY”
.
• The battery compartment also contains two additional wires marked
“EXTERNAL SOLAR PANEL *OP-
TIONAL* “
. These two wires
must never be connected to the battery
, they are used when an additional
external solar panel is installed.
INSTALLATION
1. Install the lighting fixture on a pole with an outer diameter of:
• 101mm (4in) for the LX25 and LX50 (round or square sleeve is available for LX25, LX50);
• 127mm (5in) LX95 (square sleeve only on the LX95);
2. Slide the lighting fixture on top of the pole;
3. Use the 1/4”-20 bolt to secure the luminaire to the pole, choose the drilling pattern according to your model
(LX25-50 or LX95);
4. Once the light is in place, open the battery box door and insert the battery. The battery is standing up for the
LX95. The battery is lying on its side for the LX25 and LX50 as shown in the figures below;
5. Make a quick connection with the quick connect cable;
6. A green indicator light indicates that the luminaire is functionnal.
7. Close the battery box door, the installation is now complete.
LEARNING DELAY
The light requires a 24-hour delay to operate properly according to it’s program.
STEP 1, 2, 3
STEP 4
STEP 5
Indicator lights
