,
Intensity light 1 goes on.
Note: The appliance always automatically selects the lowest light intensity
setting. See section ‘Light intensity’ in chapter ‘Preparing for use’ to determine
the appropriate light intensity.
4
To adjust the light intensity setting, press the on/off button one
or more times until you have reached the required setting.
The corresponding intensity light lights up.
5
Place the appliance at a 90° angle on the skin so that the body
attachment is in contact with the skin.
Tip: For easier use, stretch the area of skin you want to treat.
,
The ‘ready to flash’ light on the back of the appliance starts blinking
to indicate that the appliance is getting ready to release a flash.
,
When the appliance is ready to release a flash, the ‘ready to flash’
light lights up green continuously.
6
Press the flash button to release a flash.
Note: The visible light produced by the appliance is the reflection of the flash
on the skin and is harmless to your eyes. It is not necessary to wear goggles
during use. Use the appliance in a well-lit room; this reduces the perceived
brightness of the flash.
7
Release the flash button once the appliance has flashed.
8
Slide the appliance over the skin to the next area to be treated.
As long as it feels comfortable (not painful), increase the setting by
one level within the recommended range for your skin type and
apply one flash for each setting. Do not apply more than one flash
on the same spot.
9
When you have finished the treatment, press and hold the on/off
button for 2 seconds to switch off the appliance.
10
After the skin test, wait for 24 hours and check your skin for
any reaction. If your skin shows reactions, choose the highest setting
that did not result in any skin reaction for subsequent use.
ENGLISH
15
