Unpack
Remote
Control
3 AAA
Batteries
Plug with cord
(is packed at the bottom)
Support
AA
A
A
A
A
A
A
A
Top Side
LivingColors
LivingColors
Safety Instructions
Keep the plug and LivingColors away from liquids and humidity.
• LivingColors is for indoor use only. Do not use in wet locations, e.g. bathrooms or outdoors.
• LivingColors is not a toy designed to be played with by children.
• Do not place on hot surfaces.
• For safety reasons and under the terms of the warranty the LivingColors and plug must not be opened.
• Only use the plug supplied with the charger: using an plug with the wrong polarity or current can
damage your LivingColors.
Extend the LivingColors Possibilities
Fault Tracing
The LivingColors will bring you a colorful world of opportunities.
1. If, however, you face one of the exceptional situations where :
LivingColors is not providing light,
•
check your batteries in the Remote Control
•
check the connections
•
check the plug
2. Is LivingColors still not working up to standards, please call 1-800-555-0050
(also see
Warranty and Service
).
Getting Started
0
1
On/off
Color tuning
White balance
Dimming
LivingColors
Remote control
0
1
Open the battery compartment of the Remote Control by sliding the button
at the back.
Insert the 3 AAA batteries (+ and – as indicated).
Place LivingColors at a selected location on a level, stable surface. Depending on the
surface, you could consider using the support (A) especially designed for LivingColors.
Direct LivingColors towards the wall, and insert the plug into the wall socket.
A
LivingColors will show a short introduction
to the color possibilities
(this is normal).
Switch LivingColors on by pushing the
1
(on) on the on/off button.
Create your own ambience by:
1. Touching the desired color on the touch ring,
Move a finger over the touch ring for refining the color.
2. Deep full color through to white
Push the white balance button, for a shorter or longer time, on
A
( )
for a deep color or on
B
( ) for more pastel through to white.
3. Dimming
Increase (
) or decrease (
) the amount of light via the
Dimming Button.
Switch off LivingColors by pushing the
0
(off) on the on/off button.
LivingColors will remember the last setting.
0
1
A
B
0
1
Up to 6 LivingColors can be connected.
Independently:
1) Use more LivingColors independently with it’s own remote control.
They will show different colors each.
Together
2) Operate 2 (or more) LivingColors with one remote control.
They will show similar colors.
• Hold the remote control with a finger on the “on” button, close to the
front of LivingColors.
• LivingColors will flash 3 times, as a confirmation for being connected.
