
Mechanical Instructions
EN 8
LC4.5E AA
4.
4.3.5
Cover Shield of TV & Scaler Board
Figure 4-6 Cable clip on cover shield - Photo A
Figure 4-7 Cover shield of TV & scaler board - Photo B
1.
Release the two cables from the plastic cable clip (1) on the
shield (see photo A above).
2.
Remove the four fixation screws (2, indicated by arrows on
the shield) and remove the shield; notice that on one side,
the shield is not only held by two screws, but also by two
brackets (see photo A above).
4.3.6
TV & Scaler Board
Figure 4-8 Connectors on TV & scaler board - Photo A
Figure 4-9 Screws on VGA and audio connector - Photo B
1.
Very
cautiously
disconnect the LVDS cable (1) from the
panel (see Photo A). Notice that this cable is very fragile.
2.
Disconnect the six remaining cables (2) from the panel.
3.
Remove the three fixation screws (3) from the VGA
connector and the audio connector on the TV & scaler
board (see Photo B).
4.
Take the panel out of its brackets.
5.
Check if the foam/mesh connector block (4) is well
attached to the tuner (see Photo A). The tuner should
always have a good electrical contact with the antenna
input side of the metal rear I/O connector plate.
F_15390_041.eps
280205
1
F_15390_040.eps
280205
2
2
F_15390_043.eps
280205
1
2
2
4
F_15390_042.eps
280205
3