3.5 SOFTWARE PROGRAMMING
3.5.1 PREPARATION
To prepare the transceiver for programming set the switch in
the battery compartment to the programming position (A 3).
If the transceiver’s batteries are replaced or an external power
supply is connected, the transceiver will switch on automati-
cally. On the alpha display a bar sign is visible underneath the
programming sign (Fig.1, indicator (F)) and the display indicates
one of the following transceiver versions:
Transceiver
Display
Functionality
LBB 6063/02 or /04*
TB_ND
(Talk-back no display)
LBB 6063
TB
(Talk-back)
LBB 6064
TB+Dial
(Talk-back and dial)
LBB 6065
TB+PS
(Talk-back and PS)
LBB 6065
TB+Dial+PS (Talk-back, dial & PS)
* Only when an alphanumeric display is connected.
The second line of the display shows the software release ver-
sion. Indicated as follows:
SW-REL: **.**
* actual value depends on release version.
The receiver is now in the “Service mode” which provides the
following possibilities:
3.5.2 SERVICE AND INSTALLER FUNCTIONS
1
Viewing the addresses
2
Viewing the operation codes
3
Monitor mode
4
Installing mode
5
Test functions
6
Address programming
7
Operation code (opcode) programming
The selection of the above functions should be done as follows:
While the display shows the software version press the down
key. By repeatedly pressing this key the display will show:
“LANGUAGE”
(set required language)
“SHOW ADDRESS”
(for viewing address function)
“SHOW OPCODE”
(for viewing the operation code
function)
“MONITOR”
(for the monitor function)
“INSTALLING”
(for the installing function)
“TESTING”
(for the test function)
“POWER OFF ?”
(for the switching off function)
The up/down keys can be used to scroll through the list of
functions.
1.
LANGUAGE
-
Press the up/down keys until the display shows:
“LANGUAGE”.
-
Press the ENTER key.
-
Display shows:
ENGLISH
Press the down key for the following languages:
GERMAN
FRENCH
USER DEFINED (NEDERLANDS)
Press the ENTER key to set required language.
2.
SHOW ADDRESS
-
Press the up/down keys until the display shows
“SHOW ADDRESS”.
-
Press the ENTER key.
-
Display shows:
ADDRESS 0
A3A2A1A0*
* Value of actual address.
Using the up/down keys, all the addresses can be
viewed on the display.
To move to another function, press the MENU key
followed by the up/down keys until the required
function is shown in the display.
INSTALLATION INSTRUCTION 83
DP 6000 DIGITAL PAGING SYSTEM
Page 17/29
February 1997.
1
2
3
A
B
Location of programming switch
