KWR101830/01B
Manual (Draft Version)
Status :Draft, For Review
Page 5 of 14
Philips Proprietary &Confidential
Philips Home Control
Company
Restricted
2. RF Functions
2.1 RF Pairing
1) Make sure RC is within 1m distance from the STB and no other RF RCs are present.
2) Make sure the Qwerty keyboard faces upwards.
3) Press and hold
Keyboard W
and
Keyboard O
keys together for at least 5 seconds.
4) The KEYBOARD LED will start blinking, and RC is now in pairing mode.
5) Activate pairing mode on STB (STB sends activate command or reset dongle power).
6) Once the pairing is successful, the KEYBOARD LED will be turned off; otherwise, the KEYBOARD
LED will stay lit till timeout.
There will be a 30 seconds timeout for RC to be in pairing mode. Previously paired receiver shall be
retained as long as the STB did not initiate the pairing. See Note below on different pairing scenarios.
User can start from Step 1 again if pairing failed.
Note:
When a previously paired RC starts pairing with
1. Different receiver
o
Only upon successful pairing, the RC shall replace the previously paired receiver with the new
receiver.
o
If the pairing process fails or pairing timeout occurs, the previously paired receiver will be retained.
2. Same receiver
o
Previously paired information of the same receiver shall first be erased from the RC before pairing
process starts.
o
If the pairing process fails or pairing timeout occurs, the previously paired receiver will not be
retained.
At any one time,
Only one RC is allowed to be in pairing mode, i.e. no concurrent pairing is allowed.
Each RC can only work with one receiver, i.e. 1-to-1 pairing.
2.2 RF Un-Pairing
The following steps for un-pairing:
1) Make sure the Qwerty keyboard faces upwards.
2) Press and hold
Keyboard X
and
Keyboard UP
keys together for at least 5 seconds.
3) The KEYBOARD LED will start blinking slowly after 5 seconds.
4) Reset the power or battery and the RC is ready to pair again.
2.3 Remote Idling, RF Link Timeout with connection
When detected no activity, the RC will enter SLEEP mode. During SLEEP mode, RF link will be
disconnected to preserve power. Pressing any key or any gesture action will resume the RC to
ACTIVE mode almost immediately. The key-press that resumes the RC from SLEEP mode will be
remembered and transmitted.
When the RC wakes up from SLEEP mode, there may be reconnection latency depending on the RF
link condition with the receivers.
Once the RF (2.4G) link has been established, the RC will execute upon
ANY
key-press. Key presses
prior to successful RF link connection will not be transmitted.
