KWR101830/01B
Manual (Draft Version)
Status :Draft, For Review
Page 10 of 14
Philips Proprietary &Confidential
Philips Home Control
Company
Restricted
4. Infrared Function
The remote control has a default IR code table for 5 TV keys (TV POWER, VOL+, VOL-, MUTE and
AV). These 5 keys also support IR Learning.
4.1 Infrared (IR) Learn
Following are the 5 IR functions keys for IR
Learning:
Key Name
Key function
TV POWER
TV Power On/Off
VOL+
TV Volume Up
VOL-
TV Volume Down
MUTE
TV Mute
AV
Source selection
Follow the key sequences below to invoke the infrared (IR) Learning feature for a key:
Step
IR Learn Sequence
1
Press and hold “VOL+” and “VOL-” Key for 3 seconds. Release the keys, SYSTEM POWER
LED stays on; RC enters IR Learning mode.
2
Press and release a learnable key. The SYSTEM POWER LED indicator will reverse blink once
and TV POWER LED will turn ON.
3
Hold the remote to be learned at an optimum distance (3cm to 6cm); aim directly at DUAL IR
lens and press the key to be learned until SYSTEM POWER LED responds.
4
The SYSTEM POWER LED shall slow blink 2 times if learning is successful and the newly
learned code will replace the previous one.
The SYSTEM POWER LED shall fast blink 3 times if the learning fails. Previously learned code
will be kept. TV POWER LED will turn OFF.
Go back to Step 2 to select learnable key again.
5
User can learn other keys by repeating Steps 2 to 4.
6
Press “BACK” Key in IR Learning mode and will exit to normal mode.
Error
handling:
1. If a wrong key is pressed at Step 2, SYSTEM POWER LED will fast blink 3 times and go back
to Step 2.
2. If any stuck key(s) occurs in any of the learning sequence, SYSTEM POWER will fast blink 3
times, exit IR Learning mode and enter Stuck Key mode.
Please take note of the following points when performing infrared (IR) Learning:
1.
The remote will NOT exit IR Learning mode, except for the following occurrences:
1. If no key is selected within 30 seconds after entering IR Learning mode.
2. If stuck key timed out.
3. If “BACK” Key is pressed.
2.
After pressing and releasing a learnable key and waiting for the signal to be learned:
1. If there is no signal received within 30 seconds, SYSTEM POWER LED shall fast blink 3
times to indicate learning had failed and exits IR Learning mode.
2. If the same key is pressed again (See Section 7.2), SYSTEM POWER LED will slow blink 2
times and wait for a new key-press (go back to Step 2 to select a learnable key again).
3. If any other key is pressed, SYSTEM POWER LED will fast blink 3 times and wait for a new
key-press (go back to Step 2 to select learnable key again).
3.
The TV POWER LED will always be ON during IR Learning mode while waiting for a key input
or signal to be learned.
4.
When IR learning is in progress, RF functions are disabled (e.g. keys on KEYBOARD side are
locked). Only after exiting from IR Learning mode, the RF functions are resumed.
