Philips HX6962/76, Руководство

Страница: 29 / 44

28
Preparing for use
Attaching the brush head
1 Align the brush head so the bristles point in the same direction as
the front of the handle (Fig. 2).
2
Firmly press the brush head down onto the metal shaft until it
stops.
Note: When the brush head is attached, it is normal that there is a
small gap between the colour code ring and the handle.
Charging the appliance
1 Put the plug of the charger or sanitizer in a wall socket.
2
Place the handle on the charger.
The flashing light of the battery level indicator indicates that the
toothbrush is charging (Fig. 3).
Note: It takes at least 24 hours to fully charge the battery.
Deluxe recharge gauge:
Indicates amount of charge left in battery
- 3 green LEDs: fully charged
- 2 green LEDs: 67-94% charged
- 1 green LED: 34-66% charged
Note: If the battery charge of your Philips Sonicare is low, you hear 3
beeps and 1 LED on the recharge gauge flashes yellow for 30
seconds after the 2-minute brushing cycle.
Note: To keep the battery fully charged at all times, you may keep
your Philips Sonicare on the charger when not in use. It takes at least
24 hours to fully charge the battery.
Using the appliance
Brushing instructions
1
Wet the bristles and apply a small amount of toothpaste.
2
Place the toothbrush bristles against the teeth at a slight angle (45
degrees), pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline (Fig. 4).
English