Philips HX6962/76, Руководство

Страница: 32 / 44

31
Note: Using the Easy-start feature beyond the initial ramp-up period
is not recommended and reduces Philips Sonicare effectiveness in
removing plaque.
Smartimer
The Smartimer indicates that your brushing cycle is complete by
automatically turning off the toothbrush at the end of the brushing
cycle.
Dental professionals recommend brushing no less than 2 minutes
twice a day.
Quadpacer
- The Quadpacer is an interval timer that has a short beep and
pause to remind you to brush the 4 sections of your mouth.
Depending on the brushing mode or brushing routine you have
selected, the Quadpacer beeps at different intervals during the
brushing cycle. See the ‘Brushing instructions’ and ‘Personalizing
your brushing experience’ sections (Fig. 7).
The Quadpacer feature on this model has been activated. To
deactivate or reactivate the Quadpacer feature:
1 Place the handle with a brush head attached in the plugged-in
charger.
2
Press and hold mode button until:
a You hear 1 beep to indicate the Quadpacer has been
deactivated.
b You hear 2 beeps to indicate the Quadpacer has been
activated.
Cord wrap on deluxe charger
If your type includes the deluxe charger cover and base, the travel
charger is pre-installed inside the cover. If you want to shorten the
mains cord, you can store excess cord in the cord wrap feature built
into the charger base.
English
1 To separate the charger cover from the charger base, press the
two grey snap bars on the charger base and pull the white charger
cover upwards.
2
Wrap excess power cord around the grey charger base as shown
in the picture. Be sure to wrap the cord on the inside of the two
snap levers.
3
When you have stored the excess cord, guide the mains cord
through the small groove in the rear of the grey charger base.
4
To reattach the charger cover, press it down over the charger base
until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel
charger and use it without the charger cover and charger base.
Integrated cord wrap of UV sanitizer
You can store excess cord using the cord wrap feature built into the
bottom of the sanitizer.
Sanitizing
- With the UV sanitizer you can clean your brush head after every
use (Fig. 8).
Unplug the sanitizer, discontinue use and call Consumer Care if:
- The UV light bulb remains on when the door is open.
- The window is broken or missing from the sanitizer.
- The sanitizer gives off smoke or a burning smell while it is
operating.
Note: UV light can be harmful to the human eye and skin. This device
should be kept out of reach of children at all times.
1 After brushing, rinse the brush head and shake off excess water.
Warning: Do not place the travel cap on the brush head
during sanitization.
2 Place your finger in the door recess on top of the sanitizer and pull
open the door (Fig. 9).
3
Place the brush head on one of the 2 pegs in the sanitizer with the
bristles facing the light bulb (Fig. 10).
English