42
3139 115 14781
English
IMPORTANT!
Make sure the FM and AM antennas
are connected.
Tuning to radio stations
1
Press
TUNER
on the remote (or press
SOURCE
control at the front panel) to
select “
TUNER
/
FM
” or “
TUNER
/
AM
.”
2
Press
3
/
4
briefly on the remote.
➜
The display panel will show
"
SEARCH
>" until a radio station with
sufficient signal strength is found.
3
Repeat step
2
if necessary until you find
the desired radio station.
4
To tune to a weak station, press
1
/
2
briefly and repeatedly until an optimal
reception is found.
●
If the FM station reception is weak, you
can switch the FM mode from stereo to
mono. Press
SURR
button will toggle
through:
DOLBY PL II FM ST (stereo)
™
DOLBY PL II FM MONO
™
STEREO FM MONO
™
STEREO FM ST
Presetting radio stations
You can store up to 20 FM and 10 AM
preset radio stations in the memory.
Helpful Hints:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no valid frequency is detected during
Plug and Play,"
CHK ANTENNA
" appears.
Using the Plug and Play
Plug and Play allows you to store all
available radio stations automatically.
AUTO PRESET PRESS PLAY
2
PLAY PAUSE
1
SOURCE
1
For first time setup
, press
SOURCE
on front panel to select TUNER mode.
➜
"
AUTO PRESET PRESS PLAY
"
appears.
2
Press
2;
on the top panel or
2
on the
remote control to enter into auto install
mode.
➜
The system will start searching from
FM band and followed by AM band.
All the available radio stations with strong
signal strength will be stored
automatically.
➜
Once complete, the last tuned radio
station will play.
Tuner Operations
001-053-hts5500-37-Eng47
13/04/05, 4:15 PM
42
