Philips HTS5220, Руководство по обслуживанию

Страница: 9 / 44

2 - 2 2 - 2
Software upgrade will take 5 minutes
Do not switch off!
Package version: 000034.0
Software BE Completed
Software FE Completed
Software MCU1: Not started
Software Dock: 2%
Software MCU3: Not started
Software upgrade will take 5 minutes
Do not switch off!
Package version: 000034.0
Software BE Completed
Software FE Completed
Software MCU1: 1%
Software Dock: Failed
Software MCU3:
f) The set will shut down automatically when the software upgrade
is completed.
6)How to replace the defective Blu-ray Loader
a) Remove the defective Blu-ray Loader.
b) loosen the short circuit socket and remove it as shown follow:
note: 1.the short circuit socket connect 45p VFC cable on the BD
Loader ;2.the socket make the ESD protection points short circuit.
c) Assembly Blu-ray Loader to “J802”,”J900”,”J906” on the top of
BD Board as shown below.
7)BD board and Blu-ray Loader OPU matching procedure
Note: This procedure must be performed whenever the defective
Blu-ray Loader or BD Board has been replaced .
a) Loosen the short circuit socket and remove it
b) Assembly Blu-ray Loader to BD Board.
c) Power on the set , press “ ” <Home> button and input “5” “1”
“7” “7” on R/C.
d) Go into OSD Select mode and select item [5] ,then press <OK>
button on R/C as shown follow:
e) Insert empty USB device of MSC type and press <OK> button
with R/C as shown follow:
f) Using “ ” buttons on R/C input the 6-digits OPU data
given on the 1D barcode (see label on the Loader) with the on-
screen selection and press <OK> button to save each digit entered
as shown follow:
g) Press <Back> followed by <OK> button to fi nish OPU matching
and “ ”<Home> button to exit.
h) Repeat step c) and select item [6] ,then press <OK> button on
R/C as shown follow:
i)
Wait laser check to complete,press <stop> button to exit as
shown follow:
j) If laser check fails press “ ” <Home> button and repeat OPU
matching procedure.
123412
CAUTION!
This information is confi dential and may not be
distributed.Only a qualifi ed service person should
reprogram the Region Code.
J802 J900
J906
8) Produce to change Tuner grid(only for /98/51 version)
In some countries, you can switch the FM tuning grid between 50
kHz and 100 kHz. Changing the tuning grid erases all preset radio
stations.
a) Press<radio> button on R/C
b) Press <Stop> button on R/C.
c) Press and hold <Play> until (50 kHz) or (100 kHz) is displayed.
Note: repeaing the same action will toggle back to it previous
tunning grid setting.
9) Menu Language setup (only for 51 version)
a) Press “ ” <Home> button on R/C.
b) Select <SETUP>, then press “OK” button on R/C.
c) Select <preference setup>, then press <OK> button on R/C.
d) Select <Menu language>, then press <OK> button on R/C.
C) Select <English>, then press <OK> button on R/C.