Philips HTS4561/12, Руководство по обслуживанию

Страница: 11 / 45

2 - 2 2 - 2
f) The set will shut down automatically when the software upgrade
is completed.
6)How to replace the defective Blu-ray Loader
a) Remove the defective Blu-ray Loader.
b) Remove the shield cover at the top of Blu-ray Loader as shown
below.
c) Assembly Blu-ray Loader to “J800”,”J900”,”J905” on the top of
BD Board as shown below.
d) Remove soldered joint on the ESD protection points.
Note: The 2 ESD protection points on any one side must be
soldered if
o the Blu-ray Loader is OK and needs to be disconnected
from connector J802, J900 and J906 of the BD Board.
o the defective Blu-ray Loader is needed to be send back to
supplier for failure analysis and to support backcharging evidence.
K911
K:11
K:16
Top side view of OPU
Bottom side view of OPU
The ESD protection points
on the top of board
CAUTION!
This information is confi dential and may not be
distributed.Only a qualifi ed service person should
reprogram the Region Code.
Software upgrade will take 5 minutes
Do not switch off!
Package version: 000025.0
Software BE Completed
Software FE Completed
Software MCU1: Not started
Software Dock: 2%
Software MCU3: Not started
Software upgrade will take 5 minutes
Do not switch off!
Package version: 000025.0
Software BE Completed
Software FE Completed
Software MCU1: 1%
Software Dock: Failed
Software MCU3:
The ESD protection points
on the top of board
8) Produce to change Tuner grid
In some countries, you can toggle the FM tuning grid between 50
kHz and 100 kHz. Switching the tuning grid erases all preset radio
stations.
a) Press SOURCE repeatedly until RADIO appears on the display
panel.
b) Press and hold (Play) to toggle between 50 kHz or 100 kHz.
.
Note: repeaing the same action will toggle back to it previous
tunning grid setting.