Philips HTS3355, Руководство по обслуживанию

Страница: 8 / 35

2 - 1 2 - 1
System , Region Code , etc. Setting Produre
1)System Reset
a) press “OPTIONS“ button on R/C,TV will show setup menu
b) select the menu using the and on R/C
c) go preference page to do sysytem reset
2)Region Code Change
a) In open model,press”9” “9“ “9“ “9“ on R/C,then input desired
number to change region code :
1 USA
2 EU
3 AP
4 Australia ,NZ , Latam
5 Russia , INDIA
6 CHINA
3)Version Control Change
a) In open model, press “1“ “5“ “9“ on R/C
b) press “ok” button to confi rm
c) TV will show message as below:
8) Upgrading new sofeware
a) copy “sofeware fi les” into a CD-R disc
b) open the CD Door,then insert CD-R program disc
c) close the CD Door
d) VFD will show:
“Loading“
“Erase” -- erase the fl ash memory
“Writing” about 1 minute
“done “
* the system will switch off and on again automatically.
e) OSD will show:
Current model HTS3365/55
Version: 00.27.03_1 Release: 2008.05.22
region : 4 Servo: 5B.61.00.00
8032: 05.00.04.06 RISC:00.00.02.00
MCU: V10.08
IF current model does not match you set use down arrow
key on the remote to change
OK
CAUTION!
This information is confi dential and may not be
distributed.Only a qualifi ed service person should
reprogram the Region Code.
4)Password Change
a) press “OPTIONS “ button on R/C,TV will show setup menu
b) select the menu using the and on R/C
c) go preference page select “password“ to change
* 000000 is default password supplied.
5)Check on the Sofeware Version
a) open the CD Door
b) press “INFO“ button on R/C
c) TV will show the version on screen
upgrade fi le detected
Do you wish to continue with
the sofeware upgrade?
OK Cancel
f) select “OK”, OSD will show:
upgrade in process...
V336X
please do not unplug or
switch off the device.
6)Trade model
a) press “Open/Close “ button on R/C
b) Press “2” “5” “9” on R/C,VFD will display “TRA ON “ or “TRA
OFF“
8) Produce to Change Tuner Grid
(only applicable for certain regions)
In some countries, the frequency step between adjacent channels
in the (AM/MW)/FM band is 9kHz/50kHz(10kHz/100kHz in some
areas).
a) press “source” to select “FM” or “AM”
b) In “FM” or “AM” playback mode, press & hold “play/pause” button
until “Grid 9” or “Grid 10” appears
Note: repeating the same action will toggle back to it previous
tuning grid setting.
* “Grid 10” is default for/55 version.