22
Philips · Screeneo U3
Sound settings
•
Volume:
Adjust volume levels.
•
Deep Base:
Switch the deep base feature
on or off.
•
Wide Sound:
Switch the wide sound feature
on or off.
•
Equalizer:
Select a sound mode: Normal,
Pop, Jazz, Classic, Voice.
•
Audio Output:
Switch the audio output
between
Internal Speakers
and
SPDIF
.
Select
SPDIF
if you want to output audio
through
S/PDIF
connection to a digital
device (e.g. home cinema system or AV
receiver).
System settings
•
Key Stone:
Correct keystone images to be
rectangular.
•
Projection mode:
Adjust the projection to
the correct position based on different
installation of the projector.
•
Front:
Place the projector on a surface
in front of the projection screen.
•
Rear:
Place the projector on a surface
behind the projection screen.
•
Front Ceiling:
Mount the projector on
ceiling in front of the projection screen.
•
Rear Ceiling:
Mount the projector on
ceiling behind the projection screen.
•
Sleep Mode:
Set time (in minute) at which
the projector turns off automatically.
•
Screen Saver:
Set a time length after
which the lamp of the projector turns off
automatically if there is no input source.
•
Auto Power Down:
If this function is
switched on, the projector turns off
automatically after three hours.
•
Reset Lamp Timer:
Reset the lamp timer of
the projector to zero.
CAUTION!
Do not reset the lamp timer if the lamp
has not been replaced as this could
cause damage to the projector (
see
Replace the lamp, page 23
).
•
Language/Language:
Select your desired
language for on-screen menus.
•
High Altitude Mode:
Turn this function on to
prevent overheating due to low air density.
•
Shop Mode:
Special mode for retail stores.
•
Firmware Update:
Update the projector
system via a USB device.
Information display
Information
: Display the overview of the current
projector system settings and the software
versions of the projector.
