Philips HD8838/01, Руководство по эксплуатации

Страница: 11 / 36

• 9 •
This section explains how to use a milk
container for the preparation of cappuc-
cino or hot milk.
Note: Before using the milk
container, clean it thoroughly
as described in section "Cleaning and
Maintenance".
Note: The milk must be
stored in the refrigerator
and poured into the container only
when preparing a cappuccino. After
use, put the container back in the
refrigerator.
DO NOT store milk out of the refrigera-
tor for longer than 15 minutes.
Note: In order to fi ll the milk
container, remove it from
the machine.
The milk container must be filled
with whole milk at refrigerator
temperature.
Warning! It is forbidden to use
the container for any other
liquids other than drinking water.
To properly use the container, proceed as
follows:
1 Remove the top cover paying attention
to the suction pipe.
MILK CONTAINER
2 3 4
A
B C
Intenza Aroma System
Machine water hardness setting
1
WATER HARDNESS MEASUREMENT
The water hardness measurement is very
important in order to correctly manage
the “Intenza” fi lter and the frequency with
which the machine must be descaled.
Immerse the water hardness test strip
provided with the machine in water for
1 second.
Note: The test strip is only
valid for one measurement.
Check how many squares change colour
and refer to the table.
The letters correspond to the references
that are located in the base of the Intenza
fi lter. The fi lter must be adjusted based on
this measurement.
The numbers correspond to the settings
that are found for the water hardness ad-
justment that is shown in the program-
ming section.
More precisely:
1 = (very soft water)
2 =
(soft water)
3 = (hard water)
4 = (very hard water)
Once this value is known, set the water
hardness value as specified in the pro-
gramming section.
3 Replace the suction pipe inside the
container and close the cover by press-
ing it to the end.
After that, the container may be used to
brew the desired beverages.
2 Fill the container with milk: Do not
exceed the MAX level indicated on the
container.