tt
Filter coffee Cup
: drip tray in low
position.
Follow the instructions below to use your desired cup, mug or glass:
Espresso cup
or Caffè crema cup
:
drip tray in high position.
Latte Macchiato glass: completely remove
the drip tray and place the glass directly on
the machine base.
Espresso
XIJUF iCMBDLDBQTVMFw
Caffè
crema
ZFMMPX AZFMMPXDBQTVMF
Filter
coffee
CMVF iCMVFDBQTVMFw
BREWING COFFEE
Coffee preparation
1-
5VSOPOUIFNBDIJOFCZQSFTTJOHUIF0/0''
button. The
øBTIJOHCVUUPOTIPXTUIFNBDIJOFJTJOUIFIFBUJOHQIBTF
Before brewing a coffee, check that the On/Off button
and beverage buttons are constantly lit and that
there is enough water in the tank.
Never insert fingers or any other objects into the
capsule compartment. Single-dose capsules brew a
single coffee. DO NOT use capsules more than once. When
preparing an Espresso or Caffè crema, the machine performs
a prebrewing cycle. There is an audible pause in the brewing
process between the pre-brewing and brewing cycles.
Fig.1
Fig.2
Fig.3
If the compartment does not close easily, check that
the capsule is correctly inserted and that the used
capsule drawer is not full.
5-
Press the
XIJUF
button for an Espresso, the
ZFMMPX
button for a Caffè crema or the
CMVFCVUUPOGPSB'JMUFS
coffee.
6-
Coffee brewing stops automatically when the preset level is
SFBDIFE:PVDBOTUPQEJTQFOTJOHFBSMJFSCZQSFTTJOHUIFTBNF
button another time.
7-
Lift the lever to eject the used capsule into the used capsule
drawer.
8-
Enjoy your freshly brewed coffee.
With every coffee brewed, a small amount of rest
water runs into the drip tray. Therefore, empty the
drip tray regularly.
If the machine stops during the brewing process and
the service indicator light slowly flashes orange,
there is no more water in the water tank. Proceed as follows:
fill the tank with water and push the button of the drink that
was being dispensed. As soon as the desired quantity has been
reached, stop dispensing by pressing the beverage button
again.
We recommend emptying the used capsule drawer
and waste water drawer daily. Before inserting a
capsule, make sure that the used capsule drawer is not full.
If the machine has not been used for a long time, or
if the coffee cup is cold, we suggest placing the cup
underneath the spout and pressing the Espresso button
without using a capsule. The cup will be filled with hot water.
This will heat the machine and the cup.
After that, empty the cup and follow the steps below.
1-
Place a small cup, large cup or glass underneath the coffee
dispensing spout as indicated in paragraph “Adjusting the
dispensing height”.
2-
Lift the capsule compartment opening lever
(Fig.1)
.
3-
Insert a capsule
(Fig.2)
.
4-
Lower the lever to close the capsule compartment
(Fig.3)
.
Job:
4219 440 36171
Datum:
14-09-05
von:
timea.trojko
Uhrzeit:
14:08:14
Seite:
q26
Version:
--
qInlet
Objekt:
