HD7762/00 /C
5-15
DISASSEMBLY INSTRUCTIONS
Remove all removable and detachable items like the Bean
container lid, jug, fi lter holder and brush. The fi lter door
can be removed for convenience by undoing both latches
on the top and bottom side of the hinge.
Step 1: Bean container removal
To remove the complete bean container, including Duo-
Bean feature, remove the 4 screws (
C
) inside the bean
container.
C
C
C
C
Step 2: Top cover removal
The top cover can be opened by removing the four screws
(
F
) located underneath the Bean container and the four
screws (
G
) accessible from the underside of the UI panel.
F
F
F
F
G
G
G
G
Please note the cable connecting to the Inspection window
detection switch. The Water Level Indicator (WLI) cannot
be removed without damaging the Top cover. When the
top cover needs to be replaced the WLI can be reused,
when the WLI needs to be replaced a new top cover needs
to be ordered as well.
Step 3: UI panel removal
To be able to remove the UI panel, you need to disconnect
the leads to the Synchro motor, and the fl atcable to the
main PCBA. The UI panel is held in place by two screws
accessible from the top side of the appliance, and 5 clicks
accessible from the bottom side of the UI panel. Unscrew
both screws (
J
).
J
J
Undo the snaps by tracing the curve of the UI panel with a
fl at-head screwdriver, while pulling the UI panel upwards.
The UI panel can be disassembled, the rotary knob can
simply be pulled off, the rotary encoder is secured by a
single nut, remove the nut. The PCBA cover is held in place
by six screws (
L
), once unscrewed the PCBA can be taken
out. Please mind the rubber seal, preventing steam from
reaching the UI PCBA.
