Philips G3 EnviroDome, Инструкция

Страница: 22 / 48

STEP
B1
STEP
B2
To use FastAddress, skip to Step B3 . Otherwise, set
the address switch as shown. Setting address selector
to 0000 (
Not Recommended ), responds to all mes-
sages regardless of address; otherwise, the unit will
only respond to commands issued for that address.
If you are using RS-232 Communications:
The unit is shipped with the RS-232 Baud Rate set to
9600.This rate can be changed with dip switch.
The following settings pertain to AutoDome versions
2.00 and newer:
Switch 1 ON: RS-232 Baud rate = 19.2 K
Switch 2 OFF: RS-232 Baud rate = 9600
For versions prior to 2.00, use the following settings:
Switch 1 ON: RS-232 Baud rate = 9600
Switch 2 OFF: RS-232 Baud rate = 19.2 K
Carefully remove the G3 AutoDome
®
from the box.
Save all packing material, as it can be used for setting
up the camera and for transporting the dome.
If the item appears to have been damaged in ship-
ment, replace it properly in its carton and notify the
shipper. If any items are missing, notify your Philips
Communication, Security & Imaging Sales
Representative or Customer Service Representative
at the location nearest you:
The Americas: 1 800 326 3270
Europe & Middle East: 31 40 278 1222
Asia Pacific Region: 65 350 1859
or visit our Web site at www.philipscsi.com.
21
Installation Guide
In-ceiling AutoDome
NOTE: Section B applies to the In-Ceiling AutoDome.
G3_II_21918_01-37_read.qxd 9/13/01 11:17 AM Page 21