Philips FWD832, Быстрый старт

Страница: 19 / 41

English
19
Preparations
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Using Remote Control
IMPORTANT!
– Before using the remote control,
remove the insulation plastic tab as
shown in the picture below.
– If the remote control does not
function correctly or the operating range
is reduced, replace the battery with a
new (CR2025) battery.
1
2
3
CR2025
1
Push to open the battery tray.
2
Replace a new battery according to the
indicated polarity.
3
Push the battery tray back to close it.
Using the Remote Control to operate
the Player
1
Aim the Remote Control
directly at the remote sensor
(IR) on the front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote.
3
Then select the desired
function (for example,
ÉÅ
,
¡
or
™
).
CAUTION!
– Remove the battery if it is exhausted
or if the Remote Control is not being
used for a long time.
–
Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
1
Go to Standby mode.
2
Press and hold CLOCK SET on the front
panel.
➜
“
SET CLOCK
” is displayed briefly. Then, the
hour digits flash on the display screen.
3
Press SEARCH
22
/
33
(
í
/
ë
on the
remote) to set the hours.
4
Press
CLOCK SET
again.
➜
The minute digits flash on the display screen.
5
Press
SEARCH
22
/
33
(
í
/
ë
on the
remote) to set the minutes.
6
Press
CLOCK SET
to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
SYSTEM MENU
SUBTITLE REPEAT A-B SHUFFLE
SLOW DISPLAY
OSD
DISC MENU
DISC AUX