Philips EasyKey 9200, Руководство пользователя

Страница: 5 / 15

6 7
2
4 5
3 1
8 9 10
Installation steps
The following installation steps apply to left-open doors. For right-open doors,
please read the chapter [Pre-installation instructions] carefully and make
needed adjustments.
Please make sure
the main dead bolt
is retracted during
installation.
After fixing the
striker, please
test if the door
can be opened
and closed
smoothly.
Select a square shaft and connecting
screw tube with appropriate length.
M6 screw tube
M5 screw tube
Use the drilling
template to drill
the needed holes
on the door and
mount the mortise
into the door.
Pass the cable through the hole on
the door.
The square shaft needs
to be inserted into the rotary hole
on the mortise,
so that the outer
escutcheon stays close to the
outside door.
Tighten the mounting plate
with the 4 M5 chamfer
head screws against the
inside of the door.
Tighten the 4
anchor screws
on the mortise.
Tighten the M6 chamfer
head screws and the 2
M4 hexagon screws.
M6 Chamfer
Head Screws
M4 Hexagon
Screws
Put in the batteries
and close the battery
cover. Then fix the
striker to finish the
installation.
Please check if all
components are
connected properly,
such as the push-
pull handle, the safe
handle switch and
the mechanical key.
Install the connecting
screw tubes on the
outside escutcheon. Place
the square shaft and
compressed spring into
the hole of the handle.
Attention
6 7
Please hide the extra
connecting wires into
the hole of the door.
Install the compressed spring
and square shaft into the inside
escutcheon accordingly.
Insert the connection wire of the outside
escutcheon and the motor wire into the
corresponding holes on
the inside escutcheon,
then align the square
shaft on the inside
escutcheon with the
rotary hole on the
mortise and insert it to
make sure the inside
escutcheon is kept
close to the inside of
the door.
Attention
Attention
Attention
35mm square shaft
Compressed Spring