18
English
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to
match the video signal of your TV. This setting only affects
the television’s on-screen display that shows the stop and
setup modes. You may select either NTSC or PAL. To
change the DVD player setting to PAL or NTSC, follow the
steps below.
1
Unplug the DVD player from the mains.
2
Press and hold
9
and
T
on the front of the DVD player.
While holding
9
and
T
, plug in the mains.
3
After PAL or NTSC appears on the display panel of the
DVD player, release
9
and
T
at the same time. The PAL
or NTSC that appears on the display panel indicates the
current setting.
4
To change the setting, press
T
within three seconds. The
new setting (PAL or NTSC) will appear on the display
panel.
General explanation
About this manual
This manual gives the basic instructions for operating this
DVD player. Some DVDs require specific operation or
allow only limited operation during playback. In these cases,
the player may not respond to all operating commands.
When this occurs, please refer to the instructions contained
with the DVD. When the symbol
Ä
appears on the TV
screen, the operation is not permitted by the player or the
disc.
Remote control operation
¶
Unless otherwise stated, all operations can be carried out
with the remote control. Always point the remote control
directly at the player, making sure there are no obstructions
in the path of the infrared beam.
When there are corresponding keys on the front panel of
the player, they can also be used.
Menu bar operation
¶
A number of operations can be carried out via the menu
bar on the screen. The menu bar can be accessed by
pressing any of the following keys on the remote control:
MENU OSD, T, C, Angle, Audio Language, Subtitle Language
and Zoom.
¶
Pressing MENU OSD while the menu bar is displayed will
clear the menu bar from the screen.
¶
When selecting an item in the menu bar, the selected item
will be highlighted and the appropriate cursor keys to
operate this item will be displayed below the icon.
¶
< or > indicates that more items are available at the left/
right of the menu bar. Press
t
or
u
to select these items.
Turning On the power
1
Switch on the TV and select the video input channel for
your DVD- Video player.
2
Press STANDBY-ON button.
DVD 711
DVD/VIDEO CD/CD PL
STANDBY-ON
DVD 761
Initial Setup (Virgin Mode)
General
In ‘Initial Setup’ you may have to set your preferences for
some of the player’s features.
(not applicable for all models)
Operation
After switching on the player for the very first time, the
‘Initial Setup Screen’ will appear.
The menu for the first item to be set is displayed and the
first option is highlighted.
¶
Use the
w
v
keys to go through the options in the menu.
The icon of the selected option will be highlighted.
¶
Use OK to confirm your selection and to go to the next
menu.
Note:
– Preferences have to be set in the order in which the item
menus will appear on the screen.
– The ‘Initial Setup’ screen will only disappear after the
settings for the last item have been confirmed.
– If any keys other than
w
v
or OK are pressed,
Ä
will
appear on the screen.
– If the player is switched off while setting personal
preferences, all preferences have to be set again after switching
the player on again.
P
REPARATION
Содержание DVD761
Страница 1: ...1 DVDVideo player DVD761 ...
