ENGLISH
Operation
13
4
Operation
4.1
Switch-on/switch-off
Switch the receiver on by pressing the
ON/OFF
key (standby key) on the remote control and wait
until you see the welcome image on your screen.
The LED is off if the receiver is switched on.
When you switch on your receiver for the first
time, the LED is blinking while the software is
loading. Follow the steps explained in the section
Initial installation on this page.
When the receiver is in stand-by mode the LED
is green.
During a software update process the LED is
blinking.
4.2
Initial installation
After the first switch-on, the following window is
displayed on your screen.
Note
Also observe the information messages displayed
on the screen. These will help you to set the
correct values. Also with regard to further
operation, information messages are displayed.
1
Now successively set the desired values. In
doing so, observe the following:
•
By using the
arrow keys
or
, you
change the displayed values,
•
By using the
arrow keys
or
, you
switch between the individual setting
possibilities.
2
Then highlight the
OK
field by using the
arrow key
or
, and press the
OK key
.
Entering the postcode
3
Select the item
Postcode
and press the
OK
key
.
4
Use the
arrow keys
to select a figure or
letter. Press the
OK key
.
5
Repeat the previous steps until having
completely entered your postcode.
6
Again press the
OK key
.
Note
The menu item
General
allows for entering and
later changing of the postcode.
DSR220co.book Page 13 Lundi, 18. janvier 2010 6:23 18