20
English
Radio Reception
Tuning to radio stations
1
Press
SOURCE
repeatedly (or
TUNER
on the
remote control) to select the tuner source.
2
Press
BAND
on the remote control to select
the desired waveband : FM or AM.
3
Hold
S
/
T
(or
5
/
6
on the remote
control) and then release the button.
➜
The system will start searching for a radio
station with sufficient signal strength.
4
Repeat step
3
if necessary until you find the
desired station.
●
To tune to a weak station, press
S
/
T
(or
5
/
6
on the remote control) briefly and
repeatedly until you have found optimal
reception.
Programming radio stations
You can store up to a total of 20 radio stations
for each band in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press
ALBUM//-
(or
¡
/
™
on the
remote control) to select the preset number
where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press
PROG
for more than two seconds to
activate programming.
➜
All available stations are programmed.
Manual programming
1
Tune to your desired station (refer to “Tuning to
radio stations”).
2
Press
PROG
to activate programming.
➜
PROG
flashes in the display.
3
Press
ALBUM//-
(or
¡
/
™
on the
remote control) to allocate a number from 1 to
20 to this station.
4
Press
PROG
again to confirm the setting.
➜
PROG
disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
●
Press
ALBUM//-
(or
3
/
4
on the
remote control) until the desired preset station
is displayed.
TIMER
iPod
pg001-029_DCM230_37-Eng
12/6/07, 16:22
20
