ColorBlast Product Guide
11
5. Insert the fixture cable through the provided junction box gasket, and pull the
cable through the junction box.
6. Using the provided 10-24 stainless steel screws, attach the fixture base to the
junction box, ensuring that the gasket is compressed evenly.
7. Repeat steps 2 through 6 for each fixture in the installation.
8. If installing in a wet or damp location, seal all junction boxes with contractor-
grade RTV silicone sealant. Use gaskets, clamps, and other parts and fittings
required to comply with local outdoor wiring codes.
Make Power Connections
Make sure the power is OFF before mounting and connecting ColorBlast fixtures.
1. Pull cables from the fixtures to the power / data supply.
2. Pull each fixture cable through a knockout in the side of the power / data supply.
3. Connect line, common, ground, and data to a provided connector, then snap the
connector into the connector terminal inside the power / data supply housing.
4. Using wire nuts, connect the green ground wire from each fixture cable to the
earth ground on the power / data supply,
4. Repeat for each power / data supply in your installation.
.31in
(8 mm)
18 AWG
.04 in (1 mm)
Fixture cable connector dimensions
W
R
R
W
B
B
R W B
R W B
R W B
ColorBlast 12 wiring
ColorBlast 6 wiring
PDS-150e
PDS-150e
PDS-60
PDS-60
