6
4
Mark the cut-off hole and the 4 bolt holes.
5
Cut out the marked area and drill the bolt
holes.
6
Remove the grille net.
7
Strip the speaker wires and connect them
to the amplifier.
•
Black wire: connect to “-“ (negative)
terminal
•
Black (white lined): connect to “+“
(positive) terminal
Amplificador
Con línea blanca
Con línea blanca
Derecha
Derecha
Negro
Negro
Izquierda
Izquierda
Altavoz de coche
ES-AR
Note
•
Match the “left”, “right”, “+” and “-” terminals correctly.
Revised polarity may degrade sound quality.
•
Two 4-ohm speakers, wired in stereo, present a 8 ohm
load to each channel of the amplifier. Most two channel
amplifiers work well in this configuration. However, if
two 4-ohm speakers, wired in parallel to a bridged two
-channel amplifier, present a 2-ohm mono load to the
amplifier. Most 2-channel amplifiers do not support
2-ohm mono operation! Amplifier damage may result!
8
Mount on the speaker as shown below.
9
Press and insert the edges of the grille net.
Tip
•
The speaker grille can be mounted without the grille
net, if you like.
