7
EN
Connect wires
Note
•
Make sure that all loose leads are insulated
with electrical tape.
•
Consult a professional to connect wires as
instructed below.
•
Before connection, check the car's wiring
carefully.
1
Connect the ISO male connectors.
ISO male
connectors
Connect to
1
Green strip,
black-edged
green strip
Rear left speaker
2 White strip,
black-edged
white strip
Front left speaker
3 Gray strip, black-
edged gray strip
Front right
speaker
4 Purple strip,
black-edged
purple strip
Rear right
speaker
e Red strip
Ignition key +12V
DC when ON/
ACC
f
Blue strip
Motor/electric
antenna relay
control lead
ISO male
connectors
Connect to
g Blue strip, white
strip
Amplifier relay
control lead
h Black strip
Ground
i
Yellow strip
The +12V car
battery which is
energized at all
times
2
Connect other wires if necessary.
Caution
•
To avoid an accident, the driver must not
watch video while driving. By design, this
system disallows watching video during
drive. Park your car in a safe place and
engage the parking brake before watching
video.
Note
•
When the parking brake of your vehicle is
not engaged, the video blocking system
is activated. It blocks the display of front
video source only.
•
If the system is not properly connected
with the parking brake control module of
your vehicle, video signals will be blocked
by the system, with the below message
displayed on the TFT.