background image

3

Mount the luminaire with the Pole.

1

Take the product out of the packing box.

Horizontal Mounting

Vertical Mounting

Pole Dia:

to 60mm

48

Below mentioned inclinations are possible.
0°,5°,10°,15°.

0°-15°

For accurate angle positioning, marks

are made over the clamping position

of the luminaire. Match the pole
mounting piece marking with luminaire
marking

10°

15°

Tilt the luminaire by rotating it and
open the 4 screws with srew-driver.

5

Tilt the luminaire by rotating it and
open the 4 screws with srew-driver.

5

Tilt the luminaire by rotating it and
open the 4 screws with srew-driver.

5

To switch ON the luminaire Press the
switch button shown in below figure.

Switch

5

6

7

4

For Vertical Mounting installation
Unscrew the Screw and remove the
pole Mounting Bracket and assemble
it as shown in Fig. B.

7. The Light source of this luminaire is not replaceable; when the

light source reaches its end of life the whole luminaire shall be

replaced.

Luminaire

Protective
Cover

Mounting
Bracket

Shrink
Wrap

Note: Remove Shrink Wrap and Protective

cover before installation.

Fig. A

Fig. B

Note: Tightened the bolts
with torque of 8Nm.

*

Note - Representation product images and actual product may vary based on

versions

3 Core Cable

2

Pass the wire through the pole and
mount the luminaire

2. Maximum installation height is 5m.

4. After three months of manufacturing it is necessary to check the

glowing of the luminaire, if it is not working then contact to
customer care.

1. This luminaire will not operate below 0 degree ambient.

Precaution:

6. If two red and orange colour LED’s start blinking then first remove

AC input connections and press the switch to switch off the
lumianire and wait for min two minutes. Subsequently follow
same commissioning sequence as per point no. 5

3. Before installation check the luminaire by pressing the switch

and make sure that it is glowing.

5. After installation and during commissioning of luminaire, first

press the switch to switch it ON and then connect AC 230Vrms
input to the luminaire.

Отзывы: