>
If a fault occurs, first check the points listed below before taking the projector for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service
organisation.
Under no circumstances should you try to repair the projector yourself as this could invalidate the
guarantee.
–
Possible cause
•
Solution
General
–
Mains lead is not correctly connected.
•
Correctly connect mains lead.
–
Lamp holder cover is not closed correctly or the lamp holder is damaged.
•
Close the cover correctly (see ‘Lamp replacement’ under ‘Maintenance’).
–
Signal cable not correctly connected.
•
Connect signal cable correctly.
–
The projector is in Off position.
•
Press Standby to switch on the projector.
–
A/V Mute active.
•
Cancel A/V Mute.
In Video series mode
–
Keystoning is applied on a high resolution component signal.
•
Decrease keystoning until the image is correctly displayed. For this use the ‘Keystone’ option
in the ‘Setup’ menu.
In Data mode
--
Partial, scrolling or incorrectly displayed image.
•
Use the ‘Autosync’ option in the ‘Picture’ menu.
–
Input resolution is too high (and keystoning is applied).
•
If you wish to keep the keystone correction, decrease the input resolution until the image is
correctly displayed. For this, refer to the User Guide or support information of the
computer.
•
If you wish to keep the input resolution as it is, decrease keystoning until the image is
correctly displayed. For this, use ‘Keystone correction’ option in the ‘Settings’ menu.
–
Input resolution is too high (and no keystoning is applied).
•
Decrease the input resolution until the image is correctly displayed. For this, refer to the
User Guide or support information of the computer.
Warning
Read as follows
Problem
Image is not or incorrectly
displayed
Philips Multimedia Projector
27
English
User guide
bCool XG1
7.Troubleshooting
