Philips AZ5140, Руководство пользователя

Страница: 21 / 21

21
English
AZ 5140/98
page
21
TROUBLESHOOTING
Problem Solution
CD/VCD OPERATION
"
NO DISC
" is displayed – Insert a disc.
– Check if the disc is inserted upside down.
– Wait until the moisture condensation at the lens has
cleared.
– Replace or clean the disc, see "Maintenance"
– Use a readable disc or correct recorded format
MP3-CD.
No picture on TV screen – Connect the cable between the system and TV.
No colour on TV – Change the system to the respective PAL or
NTSC setting.
RADIO RECEPTION
Radio reception is poor – If the signal is too weak, adjust the antenna
for better reception.
– Increase the distance between the Receiver
and your TV or VCR.
TAPE OPERATION/RECORDING
Recording or playback cannot be made – Clean deck parts, see "Maintenance".
– Use only NORMAL (IEC I) tape.
– Apply a piece of adhesive tape over the missing
tab space.
GENERAL
The system does not react when buttons – Slide the source sector to TAPE/OFF. Remove and
pressed/set does not work/no display on reconnect the AC power plug for 30 seconds and
LCD. switch on the set again.
Sound cannot be heard or is of poor – Adjust the volume.
quality – Make sure the MP3-CD was recorded within
32-320 kbps (128kbps preferably) with sampling
frequencies at 8 - 48 kHz (44.1kHz preferably).
The remote control does not function – Reduce the distance between the remote control
properly and the system.
– Insert the batteries with their polarities (+/- signs)
aligned as indicated.
– Replace the batteries.
– Point the remote control in the direction of the
system's IR sensor.
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
P001-021_AZ5140_98-Eng 3/11/05 9:50 Page 21