DIGITAL TUNER
7
GENERAL INFORMATION
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.
Safety information
• Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
TUNING TO RADIO STATIONS
1.
Select
TUNER
source.
™
is displayed briefly and then the radio station
frequency is shown.
2.
Press
BAND
once or more to select your waveband.
3.
Press
SEARCH
∞
or
§
(for AZ 2025 model only: on the
remote control,
TUNING
∞
or
§
) and release when the
frequency in the display starts running.
™
The tuner automatically tunes to a station of sufficient
reception. Display shows
during automatic tuning.
™
If a FM station is received in stereo,
STEREO
is shown.
4.
Repeat
step 3
if necessary until you find the desired station.
• To tune to a weak station, press
SEARCH
∞
or
§
briefly and
repeatedly until you have found optimal reception.
To improve radio reception
– For
FM
, pull out the telescopic aerial. Incline and turn the
aerial. Reduce its length if the signal is too strong (very close
to a transmitter).
– For
MW (LW)
, the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning the
whole set.
AZ 2025/00
page
7
BATT
OW
English
