Quick Start Guide
The transducers are pre-warmed up to body temperature in the base station. Please advise your
patient before applying the transducer.
Two active transducers transmitting FHR to the same base station cause error message
E9
. To clear, dock one transducer.
After Use: Clean transducers. Then dock in appropriate base station slot.
Changing from US to DECG monitoring
Changing from DECG to US monitoring
1
Dock the US transducer.
1
Disconnect the DECG adapter cable M1362B and the fetal scalp
electrode from the ECG transducer.
2
Take out the ECG transducer when the lamp
for that
slot is green.
2
Dock the ECG transducer.
3
Connect the DECG adapter cable M1362B and the fetal scalp
electrode to the ECG transducer.
3
Take out the US transducer when the lamp
for that slot is
green.
4
Start DECG monitoring.
4
Start
ultrasound
monitoring.
110 - 240 V AC
Power on
Wait for “ready” lamp
“Ready” lamp goes out: “RF
Link” lamp comes on
Apply transducer (use gel for
US)
Remove transducer
Fetal monitor
M2720A Avalon CTS
Cordless Fetal Transducer System
