Using the Sonicare
Brushing instructions
1
Wet the bristles and apply a small amount of toothpaste.
2
Place the toothbrush bristles against the teeth at a slight angle
towards the gumline.
3
Press the power on/off button to switch on the Sonicare.
4
Apply light pressure to maximise Sonicare’s effectiveness and let the
Sonicare toothbrush do the brushing for you. Do not scrub.
5
Gently move the brush head slowly across the teeth in a small back
and forth motion so the longer bristles reach between your teeth.
Continue this motion throughout your brushing cycle.
Note: To make sure you brush evenly throughout the mouth, divide your mouth
into 4 sections using the Quadpacer feature (see chapter ‘Features’).
6
Begin brushing in section 1 (outside top teeth) and brush for 30
seconds before moving to section 2 (inside top teeth). Continue
brushing in section 3 (outside bottom teeth) and brush for 30
seconds before moving to section 4 (inside bottom teeth).
7
After you have completed the brushing cycle, you can
spend additional time brushing the chewing surfaces of your teeth
and areas where staining occurs. You may also brush your tongue,
with the toothbrush switched on or off, as you prefer.
Your Sonicare is safe to use on:
- Braces (brush heads wear out sooner when used on braces)
-
Dental restorations (fillings, crowns, veneers)
Brushing modes
Sonicare automatically starts in the default Clean mode.
1
Prior to switching on the Sonicare, press the mode button to toggle
between modes.
,
The selected brushing mode illuminates.
,
Once a brushing mode has been selected, it remains active until
another brushing mode is selected.
Note: When the toothbrush is switched on, you cannot toggle between modes.
The following brushing modes are available:
clean
Complete whole mouth cleaning (2 minutes).
gum care
Complete whole mouth cleaning (2 minutes) plus gentle cleaning for
problem areas and along the gumline (1 minute).
Refresh
Touch-up for a quick clean (1 minute).
1
2
4
3
EnglisH
7
