3 Use your TV
Switching on your TV and putting it in
standby mode
Remote Control
TV
To turn the TV on from standby or off to standby
•
Press
on the TV or the remote control.
Note(s)
•
Energy consumption contributes to air and water pollution. When the AC power cord is plugged
in, your TV consumes energy with a very low standby power consumption.
Adjusting volume
Remote Control
TV
To decrease or increase volume
•
Press
VOL
/
on the TV or press
VOL + / –
on the remote control.
VOL
(–) : Volume down
VOL
(+) : Volume up
To mute or unmute sound
•
Press
on the remote control to mute the sound.
•
Press
again or
VOL + / –
to recover the original sound.
Switching channels
Remote Control
TV
To select channels by using CH
/
or CH + / –
•
Press
CH
(up) /
㸦
down) on the TV or press
CH + / –
on the remote
control.
To select channels by using the NUMBER buttons
Digital TV operation
•
For digital channels, press a number followed by a dot “
•
” and the
corresponding sub channel number.
–When selecting digital channel 1 1. 1
Be sure to press
•
before entering the subchannel number.
Cable / NTSC (Analog) TV operation
–When selecting cable or analog channel 1 1
Press
PREV.CH
to return to the previously viewed channel.
Note(s)
•
To select the non-memorized channels, use
the NUMBER buttons
.
•
Channel not available
or
No signal
will appear on the TV screen after the subchannel broadcast
is over.
•
Audio only
message will appear on the TV screen, when you receive only sound signal.
21
.
English
Continued on next page.
65PFL6601 serial numbers beginning with DS4A1702 or lower numbers / 75PFL6601 serial numbers beginning with GZ1