EN 42
[3 or 4 satellites (DiSEqC 1.0)]
: Select
for 3 or 4 LNBs.
[Unicable for 1 satellite]
: Select if you
have a Unicable setup with 1 satellite.
[Unicable for 2 satellites]
: Select if you
have a Unicable setup with 2 satellite.
Manual installation
If a transponder is skipped during installation,
you can test the signal strength of a
transponder or add a new transponder.
1. While you watch TV, press .
2. Select
[Setup]
>
[Search for satellite]
>
[Manual installation]
, then press
OK
.
3. Select the LNB.
4. If you know the frequency of the
transponder (which can include several
channels), select
[Frequency]
and set the
frequency.
5. Select
[Search]
, then press
OK
.
6. If a new frequency is found, press
[Store]
to add the new transponder with its
channels.
Update satellite channels
1. While you watch TV, press .
2. Select
[Setup]
>
[Search for satellite]
>
[Update channels]
.
3. Follow the onscreen instructions to
complete the installation.
4. Once complete, select
[Finish]
, and then
press
OK
.
Add and remove satellites
You can add or remove satellites at any time,
and install channels from new satellites.
Note:
Before you add satellites, make sure
that the connection type is correct. See
Change your TV settings > Satellite Settings
> Install satellite channels
(Page 41).
1. Press .
2. Select
[Setup]
>
[Search for satellite]
,
then press
OK
.
3. Select
[Add satellite]
, then press
OK
.
The TV searches for a satellite on the first
free LNB. This can take several minutes.
4. If no satellite is found, check the antenna
connections and the position of the dish
antenna, then select
[Search again]
.
5. If you are satisfied with the added satellite,
select
[Next]
to install all channels from the
satellite.
The installation can take several minutes.
Remove a satellite
1. Press .
2. Select
[Setup]
>
[Search for satellite]
>
[Remove satellite]
, then press
OK
.
3. Select the satellites you want to remove,
then select
[Remove]
and press
OK
.
