4
Installing or removing the table stand (optional)
Step 1- Place on the table
Take off the protective sheet which was wrapped around the display when it was packaged. Lay the protective sheet on the table, beneath the screen
surface so as not to scratch the screen face.
Step 2- Fix the tube to the display (using M6xL41 screws)
Please refer to the following drawing to identify the position of screws.
55BDL4031D: Fasten the longest screw(M6x41.0mm) into Hole#3 and Hole#13 of tube to secure it to the display.
49BDL4031D: Fasten the longest screw(M6x41.0mm) into Hole#4 and Hole#14 of tube to secure it to the display.
43BDL4031D: Fasten the longest screw(M6x41.0mm) into Hole#5 and Hole#15 of tube to secure it to the display.
Step 3- Set up the stand (using thumb screws)
Table stand
Longer portions should face the front
M6xL41 screws
Thumb screws
To remove the table stands:
1. Power off the display.
2. Spread a protective sheet on a flat surface.
3. Place the display face-down on the protective sheet.
4. Remove screws using a screwdriver and place them in a safe place for reuse.
