Mechanical Instructions
4.
4.9
Mid-range Speaker Removal
1.
Remove the large plastic rear cover, as described earlier.
2.
De-solder the wires [1] from the speaker contacts.
3.
Remove screws [2].
4.
Remove the speaker.
5.
At installation of a new speaker, also glue a new piece of
foam [3] to the speaker.
Figure 4-12 Mid-range speaker removal
4.10 Tweeter Removal
1.
Remove the large plastic rear cover, as described earlier.
2.
De-solder the wires [1] from the speaker contacts.
3.
Remove screws [2].
4.
Remove the speaker.
Figure 4-13 Tweeter removal
4.11 Control Board Removal
1.
Remove the large metal rear cover, as described earlier.
2.
Remove the left stand holder.
3.
Remove screws [1].
4.
De-solder the wires [2] from the control board, or unplug
the connector on the other end of the wire from the main
board.
5.
Remove the control board.
6.
At installation of a new control board, also glue a new piece
of insulating tape to the control board.
Figure 4-14 Control board removal
G_16500_015.ep
s
2
8
1106
1
2
2
3
G_16520_040.ep
s
1
3
1206
1
2
G_16520_041.ep
s
1
3
1206
2
1
1
Содержание 42PF1000/62
