4-2
PL13.11_DC
Important precautions concerning the
LCD Panel Assembly:
1. When you disassemble/re-assemble the X-PCB
Cover
• Be careful not to break the hooks. If you pull with too
much force, the hooks may be damaged.
• When disassembling, first hold the top and bottom of
the X-PCB Cover on both ends and then moving
toward the center, lift up the top side to detach the
hooks.
• When assembling, be careful not to damage the
X-PCB Board or the COF(Chip On Film).
• Make sure the hooks are securely in place when
re-assembling.
• The screw tightening torque must be 5.2lb·in
(6kgf·cm).
2. When you disassemble/re-assemble the Front
Cabinet or Function CBA Unit
• Be careful not to break the hooks. If you pull with too
much force, the hooks may be damaged.
• When disassembling, first detach the hooks on each
end on the bottom side, then detach the remaining
hooks moving toward the center.
• Make sure the hooks are securely in place when
assembling.
• Be careful not to scratch the display panel when
assembling.
• The Function CBA Unit and Sensor Lens are fixed in
place by the hooks. Make sure these hooks are not
damaged. Make sure the Function CBA Unit and
Sensor Lens are securely in place when
re-assembling.
• The screw tightening torque must be 5.2lb·in
(6kgf·cm).
• After replacing the Front Cabinet or Function CBA
Unit, make sure the tact switches operate normally.
• Make sure to replace the Control Plate to a new one
when replacing the Front Cabinet.
(S-1)
[2] Stand Base
Assembly
(S-4)
(S-3)
[3] Rear Cover
[1] Stand Neck
Assembly
(S-2)
(S-4)
(S-4)
39PFL2608/F7
39PFL2708/F7,
39PFL2908/F7,
39PFL4208/F8,
39PFL4408/F8
Fig. D1
