4
Mechanical instructions
8
Figure 4-5
1.
Referring to previous Service position one must remove
the SSP and LSP from bottom tray by pulling back these
two panels.
2.
Disconnect the SSP from the LSP bracket.
3.
The two panels must be shifted some 25 cm to the right.
When doing this the side-assembly can be taken out of the
hinge (see figure 4.4), and placed on the bottom tray.
4.
Either the LSP-topbracket must be removed first, or the
cabling from SSP to LSP (0310 and O311) must be re-
routed outside the LSP-topbracket to get room to position
these panels.
5.
Turn the LSP 90 degrees anti clock wise and place the LSP
in the hole of the bottom tray. If needed a screw can
reinforce the stability of this position (see figure 4.5) (see
(2)).
6.
The left front hook of the SSP panel can be fixed in a
fixation-hole, that was used in previous service-position for
the right front hook of the SSP. See described movement-
action (1). (There is no right fixation hole.)
4.2.3
(Service position bottom side SSP)
1.
(See figure 4.3). Remove the two fixation screws of the
LSP-topbracket (one on the left hand side, one on the right
hand side).
2.
Disconnect wirings from cable-clamps of LSP-topbracket.
3.
In case the line transformer is changed by a bigger type a
part of the LSP-topbracket can be removed by breaking it.
4.3
Removing the LSP-top bracket
1.
(See figure 4.3). Remove the two fixation screws of the
LSP-topbracket (one on the left hand side, one on the right
hand side).
2.
Disconnect wirings from cable-clamps of LSP-topbracket.
3.
In case the line transformer is changed by a bigger type a
part of the LSP-topbracket can be removed by breaking it.
4.4
Removing the SSP from SSP-bracket
1.
Release the three fixation clamps on the right hand side of
the bracket.
2.
Press the board upwards and remove the board from the
bracket.
4.5
Removing the LSP from LSP-bracket
1.
Release the two fixation clamps on the right hand side of
the bracket.
2.
Press the board upwards and remove the board from the
bracket.
4.6
Removing the top control board
Figure 4-6
1.
See figure 4.6. Pull 2 clamps to the outer side.
2.
Top control board can be pushed down now, while it hinges
still in the front.
3.
Now the board can be pulled backwards.
4.
(If by accident the hinge in front is damaged or one of the
clamps is broken, the top control board can also be fixed by
2 screws.)
4.7
Removing the side I/O board
1.
The complete Side I/O-assembly can be lifted out of the
hinges and placed on the bottom tray of the set (see fig
4.4).
2.
The board can easily be removed out of the bracket by
releasing the fixation clamps.
4.8
Removing the mains switch/LED board
1.
Release the two fixation clamps.
2.
Pull the board backwards.
Figure 4-7
4.9
Mounting the rear cover
Before mounting the rear cover, check whether the mains cord
is mounted correctly in the guiding brackets.
CL 86532042_004.AI
240798
2
1
CL 86532042_006.ai
160798
Top control board
86532093_002.AI
051198
(4)
(4)
(5)
(6)
(5)
