4
Mechanical instructions
7
4
Mechanical instructions
4.1
Removing the rear cover
Figure 4-1
1.
Remove the fixation screws (A) of the rear cover, notice
also the screw for the side-I/O, see figure 4.1. The screw A
is only valid for the 3-scart configuration.
2.
Remove the rear cover.
4.2
Service positions
There are two predefined service positions:
1.
Service position for the top side (component-side)
2.
Service position for the bottom side (only valid for LSP)
(copper-side)
4.2.1
Service position top side
Figure 4-2
Figure 4-3
1.
Remove 1 screw in case of a 2-scart I/O coverplate and 2
screws in case of a 3-scart I/O coverplate (see figure 4.2).
2.
Remove the I/O coverplate by releasing the snap at the left
side. Pull the I/O cover plate to the left and then backwards.
The I/O-bracket hinges at the right side. It can be removed
now.
3.
Pull backwards (about 8 cm) the bracket with the SSP and
the LSP. These brackets are not fixed to each other, but
can be repositioned backwards, as if they were one
bracket.
4.
Hook the brackets in the first row of fixation-holes of the
bottom tray; see figure 4.3. In other words re-position the
fixation from (1) to (2).
4.2.2
Service position bottom side (only for LSP)
Figure 4-4
CL 86532042_001.AI
160798
A
A
A
A
A
or
A
A
A
A
A'
A
A
A
or
or
or
CL 86532042_003.ai
090698
CL 86532042_002.AI
240798
2
1
2
1
Side I/O assembly
SSP - bracket
LSP - bracket
Bottom tray
LSP - topbracket
CL 86532042_005.ai
090698
