Mechanical Instructions
4.
4.8
Assembly/Panel Removal Rubens Styling
(9000-series)
The instructions apply to the 32PFL9705x/xx.
4.8.1
Rear Cover
Warning:
Disconnect the mains power cord before you remove
the rear cover.
1.
Remove the stand.
2.
Remove all screws of the rear cover.
3.
Lift the rear cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
4.8.2
Speakers
Tweeters
Each tweeter unit is mounted with one screw.
When defective, replace the whole unit.
Subwoofer
The central subwoofer is located in the centre of the set, and is
mounted with three screws.
When defective, replace the whole unit.
4.8.3
Main Power Supply
Refer to
for details.
Figure 4-19 Main Power Supply
1.
Unplug all connectors [1].
2.
Remove the fixation screws [2].
3.
Take the board out.
When defective, replace the whole unit.
4.8.4
Ambilight Units
Refer to
for details.
Note:
the Ambilight units are to be swapped on PWB level.
Figure 4-20 Rim
Figure 4-21 Ambilight units
1.
Remove the tweeters as described earlier.
2.
Remove the IR/LED panel as described earlier.
3.
Unplug the connector on the PSU panel [1].
4.
Remove the screws [2] that secure the plastic rim.
5.
Remove the brackets [3].
6.
Unplug the flat foil(s) [4].
7.
Release the clips [5] that secure the PWB.
8.
Slide the PWB out of the set [6].
4.8.5
Small Signal Board (SSB)
for details.
Figure 4-22 SSB
1.
Unplug all connectors [1].
2.
Slide the side cover sidewards [2].
3.
Remove the fixation screws [3].
4.
Remove the bottom cover downwards [4].
4.8.6
IR & LED Board
for details.
1
8
750_110_100415.ep
s
100415
2
2
2
2
2
2
2
2
1
1
8
750_11
3
_100415.ep
s
100415
3
1
2
2
1
8
750_114_100415.ep
s
100415
6
6
4
5
5
7
1
8
750_111_100415.ep
s
100415
1
1
1
3
3
4
3
3
3
3
4
2
2