Mechanical Instructions
4.
4.11.2 AmbiLight Panel
Refer to
for details.
1.
Gently release the clips from the FFC connector [1] that
connect with the SSB.
2.
Gently release the clamps and unplug the connectors [2],
[3] that secure the ambilight panels. Release the clips from
the FFC connector that connect with the Ambilight control
panel.
3.
Lift the Ambilight panel from the rear cover. Make sure that
wires and flat foils are not damaged while lifting the
ambilight panel from the rear cover.
Figure 4-52 Ambilight
removal
4.11.3 Small Signal Board (SSB)
Refer to
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
2.
Unplug all other connectors [2] and the FFC connector [3].
3.
Remove all the fixation screws from the SSB [4].
4.
The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
for details.
Figure 4-53 SSB removal
19617_106.eps
3
1
2
19617_107.eps
2
1
3
4
4
4
4