Mechanical Instructions
4.
4.5.2
AmbiLight Panel
Refer to
for details.
1.
Gently release the clamps and unplug the two connectors
[1, 2,3] that secure the ambilight panels. Release the clips
from the FFC connector that connect with the AmbiLight
control panel [3].
2.
Lift the AmbiLight panel from the rear cover. Make sure that
wires and flat foils are not damaged while lifting the
ambilight panel from the rear cover.
Figure 4-35 Rear cover removal [1]
4.5.3
Small Signal Board (SSB)
Refer to
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
2.
Unplug all other connectors [2].
3.
Remove all the fixation screws from the SSB [3].
4.
The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
for details.
Figure 4-36 SSB removal
19613_106.eps
3
1
2
19613_107.eps
2
1
3
3
3
3